Concept built by Novyx for AcDc Electrical Services Llc. Not affiliated with them, and nothing here is live.

Electrician

Heating & Cooling in Ethridge

What the job involves, what it usually runs to, and how soon we can be out.

Get a free quote Call (931) 271-9603

How we handle it

The price comes firstPriced before the work begins, not after it is finished.
Licensed and insuredLicensed, insured, and happy to show you both.
No call out chargeNo call out charge to come and look at it.
The panel gets labelledPanel photographed and labelled before anything is touched.

Not sure which one you need? Describe it in the form and we will tell you before anybody comes out.

What it costs

Three shapes of job, and what each one runs.

Electrical work is priced by what the panel and the circuits actually need. Typical 2026 regional ranges.

Service

Repair or add a circuit

A dead outlet, a tripping breaker, a new dedicated circuit.

$150 - $900per visit

Fault traced and shown to you
Circuit tested and labelled before we leave
Panel photographed before anything is touched
Licensed and insured, and happy to show both

Get your number

Upgrade most common

Panel or service upgrade

A full or obsolete panel, or a house about to add real load.

$2,000 - $5,500installed

Load calculation, so the size is right for what you will actually run
New panel with every circuit labelled properly
Permit pulled and the inspection booked
Utility coordination for the disconnect

Get your number

Project

EV, generator or rewire

Adding a charger or generator, or replacing old wiring.

$1,200 - $18,000depending on scope

Charger, generator or rewire specified against the real load
Rebate and incentive paperwork where it applies
Staged so the house keeps power through the work
Full test report at handover

Get your number

What moves the number

What the existing panel and service can carry today
How far the new circuit has to run and what it passes through
Whether walls are open or the work has to be fished
Permit and inspection, which serious work always needs
Whether the utility has to be involved in a service change

These are typical regional ranges for 2026, not a quote. Every job is different and the only number that matters is the one you get in writing after somebody has seen it. This is here so you know the scale before you pick up the phone.

Recent work

Before you call

The questions we get asked most.

Why does my breaker keep tripping?

Because it is working. Either the circuit is carrying more than it is rated for, or there is a short or ground fault. Repeatedly resetting a breaker that keeps tripping is the one response that is genuinely dangerous.

Do I need a panel upgrade?

It comes down to capacity and condition. A full panel with no spaces, a fuse box, or certain brands that are no longer considered safe are all reasons. Adding an EV charger, heat pump or shop usually forces the question.

Is old wiring dangerous?

Not automatically. Knob-and-tube and cloth-covered wiring can be intact and working, but neither has a ground, both were designed for a fraction of today's load, and insurers increasingly will not cover a house with them.

What does adding an EV charger involve?

A load calculation first, then a dedicated 240-volt circuit sized to the charger and a run from the panel to where the car parks. If the panel cannot carry it, the panel comes first, which is why the calculation happens before the quote.

Does electrical work need a permit?

Panel changes, new circuits and service upgrades do. A permit means an inspection, and an inspection is the only independent check that the work is right. A contractor who wants to skip it is telling you something.

Everything else we do

Residential Electrical Commercial Electrical Pole Barn Wiring Generator Services Emergency Service

Get a quote

Power you never have to think about.

Tell us what you need and when suits. We come back the same day.

(931) 271-9603

Send it over

A name, a number, and a line about the job.